Skip to content

Driveshaft manufacturing and balancing

We manufacture driveshafts to vehicle or equipment specifications and individual orders. If an existing driveshaft cannot be repaired, we can discuss manufacturing a replacement.

Request manufacturing

High-quality driveshaft manufacturing

We manufacture driveshafts according to individual orders or in cases where the driveshaft cannot be repaired.

1-year warranty on repairs and new driveshafts

Parts matched to driveshaft requirements

Fast and high-quality service

Experienced specialists

Submit a request for the manufacturing of a new driveshaft

Fill out the application form so that we can evaluate the cost and time frame of the work. We will contact you to validate our offer.

Request manufacturing
How Are Driveshafts Manufactured?

We select driveshaft components and manufacturing parameters to suit the vehicle or equipment requirements. Production includes welding, geometry checks and balancing. Newly manufactured driveshafts carry a one-year warranty.

Tube fitting and processing

To ensure the highest safety and longevity of the driveshaft, we use seamless tubes. Our specialists fit the tube according to the specified parameters. The tube ends are machined at a specific angle to create a welding seam. The tube ends are then heated and pressed together with the assembled driveshaft parts.

Welding

To prevent the driveshaft from twisting during welding, spot welding is performed at four points. The welding nozzle is positioned at the correct angle relative to the driveshafts axis, and the welding parameters—current strength, voltage, and cardan rotation speed—are set. To ensure a precise weld seam joint, a specific section of the flange is welded twice.

Alignment

After welding, the driveshaft is cooled and moved to an alignment press, where its geometry is checked. If any deformation is detected, it is corrected to the minimum possible level.

Driveshaft balancing

We check the straightened driveshaft on a balancing machine. Where needed, weights are welded at the points identified by the machine. Contact AutoCardan to discuss balancing requirements for your driveshaft.

Contact AutoCardan

This site is protected by reCAPTCHA.This site is protected by reCAPTCHA.
Call Now Button